How to install iCam (sky fixed)

cccam Support

#To install and configure icam, physical access to the device is required. Please do not send a ticket in this regard.

1- Installing OScam:

I have included the latest version of OScam that supports Sly De below.
Put the IPK in the /tmp folder on your box and then install it with the IPK installer.
Run a newer OScam, it should be configured with all the settings needed to run Sly De.
If not then just add this to yourself

oscam.config (If the amount is not streamrelay, add it)

*This file (oscam.config) is created by the device itself and we do not have a file, please do not send a ticket

stream_ecm_delay                 = 5
stream_relay_ctab                 = 098D
stream_relay_icam_ctab        = 098D

2-Setting up your Enigma2 Box:

In order to run Sly De, you need a specific list of channels. I’ve linked an IPK file that will automatically add them for you!
At this point, just put the file in /tmp and then install it using the IPK installer
Now go to your OpenWebif and click Settings > Customize
and edit the options below:

Include ECM in HTTP streams              - NO
Descramble HTTP streams                  - YES
Descramble received HTTP streams     - NO
Load unlinked userbouquets               - YES

If you can't do the above steps, try the automatic installation method:

If the above steps are difficult for you, please factory reset your device and then run the following command in the command line:

You need ssh software to connect to the command line. We have put the direct link of PuTTY software below: